©Copyright 2003-2005 Marvell®.
All rights reserved.
SetupVCTwin.htm created 04-Aug-2005
Readme File for SETUPVCTWIN.exe v2.13.1.3
Marvell Yukon Family Ethernet Controller
This file contains
The Virtual Cable Tester(TM) installation package
contains the Marvell Virtual Cable Tester(TM)
application.
This README file explains how to install the Virtual
Cable Tester(TM) Package on a machine running Windows
2000, Windows XP, Windows Server 2003 and 64-bit extended
Windows.
NOTE:
The Marvell Virtual Cable Tester(TM) can only be used
with Windows 2000, Windows XP, Windows Server 2003 and
64-bit extended Windows.
To install the Marvell Virtual Cable Tester(TM), the
following file is required:
SetupVCTwin.exe
NOTE:
To install the Marvell Virtual Cable Tester(TM) make sure
that you are logged in as a user with administrative
rights.
To install the Marvell Virtual Cable Tester(TM), proceed
as follows:
1. Execute the setup file SetupVCTwin.exe.
2. Follow the instructions of the installation procedure.
If you should encounter any problems with your Marvell
Virtual Cable Tester(TM) Package, please re-read the
instructions above and the documentation supplied with
the operating system carefully.
Additionally refer to your system event log file (using
the Event Viewer) and check it for entries from Marvell
Virtual Cable Tester(TM).
If your particular problem is not listed or the error
persists, please send your system event log file or at
least the event id number and the logging data (as WORDs)
of the entries made by Marvell Virtual Cable Tester(TM)
to our technical support.
For further information please contact support.
*** End of Readme File ***